Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
3.
Remove the SCDS.
4.
With the brake fluid reservoir cap removed, observe for brake fluid dripping/draining from the SCDS fitting. As soon as brake fluid begins to
bleed from the fitting, install the new SCDS and tighten to 18 Nm (13 lb-ft).
5.
Check the brake fluid level at the master cylinder, fill to maximum fluid level and install the brake fluid reservoir cap.
6.
Disconnect the speed control servo and inspect the vehicle harness connector for heat damage. See Figure 4.
^
If no heat damage is found at the speed control servo connector (even if there is presence of brake fluid in the connector), proceed to new step.
^
If the speed control servo connector is heat damaged, call the Special Service Support Center for further instructions.
7.
With the speed control servo disconnected, use shop air only to blow the SCDS harness electrical connector and the servo connector dry of any
trace of brake fluid. Do not use any type of solvent to clean the connectors.
8.
Cut approximately 3 mm (1/8 in) off the grease tube applicator tip.
9.
Before installing the jumper harness, fill the vehicle harness end of the jumper (male pin connector end) with Motorcraft Electrical Grease II
XG-15-A. See Figure 5.
10.
Install the adapter jumper harness by connecting it to both the SCDS and the vehicle harness. Using the provided tie strap, secure the jumper
harness to a nearby component such as the speed control cable or another wire harness.
NOTICE:
Be sure to apply an adequate amount of grease to the vehicle harness connector only. DO NOT apply the grease directly to the connector of the servo
module.
