Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
-
All other vehicles call the Special Service Support Center for further instructions.
2. With the speed control servo disconnected use shop air to blow out any trace of brake fluid from the speed control servo harness electrical
connector and the servo module. Do not use any type of solvent to clean the connectors.
3. Apply a 5 mm (3/16 in) high bead of Motorcraft Electrical Grease II (XG-15-A) across the entire width and length of the servo vehicle harness
connector (See Figure 7).
NOTICE:
Be sure to apply an adequate amount of grease to the vehicle harness connector only DO NOT apply the grease directly to the connector of the servo
module.
4. Reconnect the harness to the servo module.
5. If the vehicle is a 1999-2OO3 Windstar proceed to ABS inspection. Otherwise no further action is required, release the vehicle.
ANTI-LOCK BRAKE SYSTEM (ABS) INSPECTION
NOTE:
This inspection applies to 1999 through 2003 Windstar vehicles only.
1. Lift vehicle and remove ABS cover.
2. Disconnect ABS module. Inspect the ABS harness and module connectors for the presence of brake fluid.
3. If brake fluid is present use shop air to blow out any trace of brake fluid from the harness connector and module.
