Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
9. Slightly loosen the camshaft holding tools to allow slight camshaft movement. Rotate the LH camshaft with the Camshaft Positioning Tool until
the timing mark is approximately at 12 o'clock.
Rotate the RH camshaft with the Camshaft Positioning Tool until the timing mark is approximately at 11 o'clock. Tighten the Camshaft Holding
Tools to maintain camshaft propositioning.
10. Use the (A) Camshaft Positioning Tool to position the (B) camshaft.
CAUTION: Do not turn the engine over with the camshaft positioning tool or damage to the camshaft sprocket or the bolt may occur.
11. Position the crankshaft with the Crankshaft Holding Tool.
CAUTION:
-
Unless otherwise instructed, at no time when the timing chain/belts are removed and the cylinder heads are installed is the crankshaft or
camshaft to be rotated. Severe piston and valve damage will occur.
-
Rotate the crankshaft counterclockwise only. Do not rotate past position shown or severe piston and/or valve damage can occur.
12. Remove the Crankshaft Holding Tool
