Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Blower Motor: Service and Repair
Auxiliary Blower Motor
REMOVAL
1. If equipped, remove the third, fourth, and fifth bench seats as required.
2. If equipped, remove the trim panels.
-
Remove the left center bolster trim panel.
-
Remove the quarter trim rear upper panel.
-
Remove the lower rear body side trim panel.
3. Remove the blower motor.
1. Disconnect the electrical connector.
2. Remove the blower motor housing tube.
3. Remove the screws.
4. Remove the blower motor.
4. Remove the blower motor wheel.
1. Remove the retaining clip.
2. Remove the blower motor wheel.
NOTE: Note the location of the blower motor wheel on the blower motor.
INSTALLATION
1. Follow the removal procedure in reverse order.
