Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
1.
Press the outlet of the Low Flow Injectors (6) & (7) into Compuvalve (4) (Figure 1).
2.
Route wires under the outlet portion of the Low Flow Injectors (6) & (7) 50 that the wires will not become pinched between Compuvalve (4) and
the Injector Fuel Rail (3) (Figure 1)
3.
Install 0-ring (5) into Compuvalve (4) as shown (Figure 1).
4.
Press Injector Fuel Rail (3) onto the inlet of Low Flow Injectors (6) & (7) (Figure 1).
5.
Apply Loctite 272 to the threads of mounting screws (2) (Figure 1).
6.
Line up the two holes in the Injector Fuel Rail (3) with the mounting holes in the Compuvalve (4) and install with mounting screws (2). Torque to
2-2.5 N.m (18-22 Lb-in) (Figure 1).
CAUTION
ENSURE THAT INJECTOR WIRES ARE NOT PINCHED UNDER INJECTORS OR INJECTOR FUEL RAIL.
7.
Insert cable tie (1) through the cable tie holder (8) and gently tighten Low flow Injector Assembly (A) harness (Figure 1).
8.
When complete, install Compuvalve (4) to the vehicle and leak test all removed components and fittings. Refer to Service Manual GFIP162 for the
1996 CNG Bi-Fuel model year and Service Manual GFIP173 for the 1998 CNG Bi-Fuel model year. For Bi-Fuel vehicles for the 1999 through
2003 CNG Bi-Fuel model years and 2000 through 2003 LPG Bi-Fuel model years, refer 10 Workshop Manual Section 310-00C.
Parts Block
OTHER APPLICABLE ARTICLES: 03-10-4, 02-10-4
SUPERSEDES: 02-10-5
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 206000, 601300, 602300, 603300, 607000, 607400, 608000, 609000, 609400, 611000, 611500
Disclaimer
