Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
^
If any other cylinder is indicated during the power balance test, then the CMP synchronizer assembly HAS BEEN INSTALLED
INCORRECTLY, and must be reinstalled. (Refer to the installation procedure, tool chart shown and TDC reference described in this TSB, or
refer to the appropriate model year Workshop Manual Section 303-14, Synchronizer-Camshaft).
5.
If power loss is indicated in the # 1 cylinder (Figure 4), connect a 104 pin break-out box between the PCM and the PCM electrical connector.
6.
Insert the red WDS probe into pin # 21 and the black WDS probe into pin # 85 of the break-out Box.
