Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
6. Before installing the adapter jumper harness, fill the vehicle harness end of the jumper (male pin connector end) with Motorcraft Electrical Grease II
(XG-15-A) (See Figure 5).
7. Install the adapter jumper harness by connecting it to both the SCDS and the vehicle harness. Using the provided tie strap, secure the adapter jumper
harness to a nearby component such as the speed control cable or another wire harness.
^ If the vehicle has a speed control servo, proceed with speed control servo inspection.
^ If the vehicle is a 1999-2003 Windstar that does not have speed control, proceed with ABS inspection.
^ If none of the above apply, no further action is required, release the vehicle.
SPEED CONTROL SERVO INSPECTION
1. Disconnect the speed control servo and inspect the vehicle harness connector for heat damage (See Figure 6)
^
If no heat damage is found at the speed control servo connector (even if there is presence of brake fluid in the connector) proceed to step 2 for
further instructions.
^
If heat damage is found proceed as follows:
-
1999-2003 Windstar complete ABS inspection before calling the Special Service Support Center for further instructions.
