Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Output Shaft: Testing and Inspection
1. Inspect the output shaft for wear. Make sure the (B) cup plug orifice and lube passages through output shaft are clean and free of debris. Replace
as required.
CAUTION: Build-up of contamination can block the flow of lubricant behind the cup plug and cause transmission assembly damage.
NOTE: The (A) anti-seepage seal is intended for shipping purposes only. It is not necessary to remove and reuse this seal when replacing the
output shaft.
NOTE: The output shaft cannot be disassembled and must be replaced if damaged.
2. Inspect the bearing surfaces of the output shaft for wear or scores. If excessive wear or scores are found, replace output shaft and inspect mating
components.
3. Check the splines on the output shaft for wear. Replace the output shaft if the splines are excessively worn. Inspect all the bushings for wear.
Replace if worn or damaged.