Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Shifter A/T: Service and Repair
REMOVAL
1. Remove the instrument panel cluster opening finish panel assembly.
2. Remove the ignition switch lock cylinder.
1. Position the lock cylinder to RUN.
2. Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.
3. Remove the upper steering column shroud.
4. Remove the transmission range selector lever. Disconnect the electrical connector.
INSTALLATION
1. Follow the removal procedure in reverse order.
NOTE: The transmission range selector lever pin must be replaced whenever it is removed.
