Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
7.
Unclip PRNDL indicator from instrument cluster, then position indicator away from cluster. See Figure 3.
8.
Pull instrument cluster away from instrument panel, then disconnect cluster electrical connectors.
9.
Remove instrument cluster from vehicle.
10.
Connect electrical connectors to new instrument cluster.
11.
Connect battery negative cable.
12.
Turn ignition switch to ON position. Do not start engine.
13.
Verify instrument cluster displays the corrected mileage. This should have been recorded on the repair order when the speedometer gear order was
placed. It corrected mileage is not displayed, call Instrument Cluster Ordering Center at 1-800-259-9700 to order a new cluster with the corrected
mileage.
14.
Disconnect battery negative cable.
15.
Install instrument cluster into instrument panel.
16.
Clip PRNDL indicator onto instrument cluster.
17.
Install instrument cluster lens.
18.
Install instrument cluster retaining screws. Tighten screws to 2-3 N-m (18-27 lb-in).
19.
Install left instrument panel finish panel. Tighten retaining screws securely.
20.
Install headlamp switch knob and bezel.
21.
Connect battery negative cable, then disconnect memory saver.
22.
Prepare original instrument cluster for shipment back to service center.
23.
Raise and support vehicle.
