Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Stator to Impeller Interference Check
1. Position the stator support with the splines up.
CAUTION: To perform this check, do not use the pump stator support which will be installed in the transmission. Damage to the pump stator
support, front pump seal or front pump stator seal may occur.
NOTE: Obtain a scrapped pump. Remove the stator support. This can be used as a permanent tool to perform this check.
2. Mount the (A) torque converter on the (B) stator support so that the splines on the one-way clutch inner race engage the mating splines of the
stator support.
3. Hold the stator support stationary and rotate the torque converter counterclockwise.
-
The torque converter should rotate freely, with no signs of scraping.
-
If there are signs of scraping, replace the torque converter.
CAUTION: On diesel applications the torque converter with multi plate clutches may rattle and make some scraping noises. This is normal.
Stator to Turbine Interference Check
1. Position the torque converter with the converter hub up.
2. Install a pump stator support, engaging the mating splines of the stator support shaft.