Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
2. Remove the bearing caps.
CAUTION: Mark the position of the bearing caps as arrows may not be visible. The bearing caps must be installed in their identical locations
and positions.
8. Use the pry bar and the wood block to remove the differential case from the rear axle housing.
WARNING: BE CAREFUL NOT TO ALLOW THE DIFFERENTIAL CASE TO FALL.
CAUTION: Place a wood block between the pry bar and the rear axle housing to protect the machined surface from damage.
9. Remove the ring gear bolts.
10. Insert a punch in the bolt holes. Drive off the ring gear and, if necessary, the anti-lock speed sensor ring.
NOTE: The anti-lock speed sensor ring cannot be reused once removed.
