Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
'
1. For Model 60-1U full-float axles, use a small drift to remove the differential pinion shaft lock pin retaining the differential pinion shaft. For Model
60-1U semi-float rear axles, a differential pinion shaft lock bolt is used to secure the slip-fit differential pinion shaft.
NOTE: An axle shaft placed in a vise, with the splines extending not more than three inches above the jaws of the vise, makes an excellent
holding fixture after the differential case has been removed from the rear axle housing.
2. Remove the differential pinion shaft.
-
For the Model 60-1U full-float axle, use a hammer and drift to remove.
3. Position the Step Plate into the bottom of the differential side gear. Apply grease to the centering hole of the step plate.
