Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
NOTE: The Gauge Block must be offset to obtain an accurate reading.
7. Install the Gauge Tube.
1. Position the Gauge Tube.
2. Install the differential side bearing caps.
3. Install the four differential side bearing cap bolts.
8. Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
After the proper shim thickness has been determined, remove the Gauge Tube.
NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the
Gauge Tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of
integral rear axle assemblies.
9. Use a press and Pinion Bearing Cone Replacer to press the pinion bearing until it is firmly seated on the pinion and pinion shim.
