Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
8. Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
After the proper shim thickness has been determined, remove the Gauge Tube.
NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the
Gauge Tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tool contact in the final assembly of
integral rear axle assemblies.
9. Use a press and the Pinion Bearing Cone Replacer to press the pinion bearing until it is firmly seated on the pinion and pinion shim.
10. Place a new collapsible spacer on the pinion shaft against the pinion stem shoulder.
11. Install the drive pinion in the drive pinion carrier bore from inside the rear axle housing.
Seat the drive pinion with a plastic hammer.
