Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
1. Follow the removal procedure in reverse order.
-
Coat the pinion seal (rubber lips) with Premium Rear Axle Lubricant XY-8OW90-QL or equivalent meeting Ford specification
WSP-M2C197-A.
CAUTION: Installation without the proper tool can result in early seal failure. If the pinion seal becomes cocked during installation, remove
and install a new one. Use care to ensure the garter spring remains in place during assembly. If the spring is dislodged, the pinion seal must be
replaced.
NOTE: Drive the pinion seal into the housing, using the Pinion Seal Replacer for Model 60 or 70 axle.
NOTE: The rear axle universal joint flange must never be hammered on or installed with power tools.