Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
1. Press the dust slinger on the coupling shaft.
2. Install the driveshaft center bearing support.
1. Install the rubber insulator in the driveshaft center bearing bracket.
2. Using a suitable press, install the driveshaft center bearing support assembly onto the coupling shaft.
NOTE: Press the bearing on the coupling shaft with the turned-in lip toward the dust slinger.
NOTE: The driveshaft center bearing bracket must be installed with the deep flange rearward.
3. Install the driveshaft center bearing retainer.
4. Slide the small opening end of the driveshaft slip-yoke boot on the splined stub shaft as far as it will travel.
5. Install the driveshaft slip yoke boot clamp, and use Keystone Clamp Pliers to crimp the driveshaft slip yoke boot clamp.
