Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Drive/Propeller Shaft: Service and Repair
Removal and Installation
One Piece
REMOVAL
1. Raise and support the vehicle.
2. To maintain driveline balance, index the driveshaft flange yoke to the rear axle universal joint flange.
3. Remove the driveshaft.
1. Remove the four driveshaft-to-driveshaft rear axle companion flange bolts, and lower the driveshaft.
2. Slide the driveshaft rearward off the transmission output shaft.
-
Plug the extension housing to prevent fluid loss.
NOTE: Index-mark the slip yoke to transmission output shaft.
INSTALLATION
1. Follow the removal procedure in reverse order.
2. Inspect the extension housing seal for damage. Replace if necessary.
3. Lubricate the slip-yoke spline with Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.