Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
10. Carefully remove the windshield glass from the vehicle.
CAUTION: Removing the glass requires more than one technician.
11. Remove the windshield header seal.
12. Trim the remaining urethane on the pinch weld to within the specification.
-
The old urethane must be smooth and free of cuts and contamination.
INSTALLATION
1. Check the pinch weld for damaged sheet metal, raised sheet metal at the spot welds, rust or foreign material that could cause glass damage.
2. Apply Urethane Body Primer WSB-M2G23C (black) to any exposed metal on the pinch weld.
-
Do not apply the primer to the existing urethane bead.
-
Let the primer dry for a minimum of 6-10 minutes before proceeding.
3. If re-installing the same windshield glass, remove all remaining traces of urethane sealant.
4. Install the windshield header seal on the windshield glass.
5. Properly align the windshield glass to the body, mark the windshield glass, and remove the windshield glass from the vehicle.
1
Place the windshield glass in the opening, and center it from top to bottom and side to side with about equal clearance on all sides.
2
Make alignment marks on each of the four sides of the windshield glass.
3
Remove the windshield glass from the vehicle, and place it inside up.
6. Clean the inside of the windshield glass with an alcohol-free cleaner.
7. Apply Urethane Glass Primer Wipe WSB-M5B280-C2 (red) to the entire inside perimeter of the windshield glass. Wipe off immediately after
each application.
NOTE: Apply with deliberate strokes, making sure not to overlap the applied area.
8. Apply Urethane Glass Primer WSB-M2G314-B (black) to the entire inside perimeter of the windshield glass. Allow a minimum of 5 minutes
drying time.
