Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
NOTE:
THIS KIT CAN BE USED ON UP TO 24 VEHICLES. RETAIN BRUSHES AND ETCHING CREAM UNTIL ALL STENCILS HAVE BEEN
USED OR ALL VEHICLES HAVE BEEN COMPLETED.
1.
Wear rubber or neoprene gloves and safety glasses.
2.
Perform work in a well-ventilated area.
3.
Use drop cloth or equivalent to protect hood and leaf screen from accidental drips/spillage of etching cream.
CAUTION:
Failure to allow windshield to reach from room temperature will affect transfer of stencil and could neutralize etching cream.
4.
Allow windshield to reach room temperature (approximately 70° F).
CAUTION:
Moisture or windshield will neutralize etching cream.
5.
Clean and dry outside surface of windshield, in area around trademark.
APPLICATION OF STENCIL
1.
Remove the white backing sheet from the frosted AS1, blue field stencil.
2.
Position AS1 stencil on windshield as follows:
^
Select proper location for AS1 stencil from examples shown in Figure 1.
