Econoline E350 1 Ton V8-5.4L SOHC VIN L (1999)
Wheel Fastener: Service and Repair
Rear
Special Tool(s)
Removal
CAUTION: Never use a hammer to remove the lug bolt. Damage to the axle flange, hub flange, wheel bearing or hub bearing can result.
1. Raise the vehicle and install safety stands.
2. Remove the wheel and tire assembly.
3. If drum brake, proceed to Step 4. Remove the rear disc brake caliper, rear disc support bracket and rear brake disc if so equipped. Support rear
disc brake caliper with safety wire.
4. Remove the rear brake drum.
5. Using C-Frame and Clamp Assembly Tool, press the wheel stud from its seat and discard.
Installation
CAUTION: Never use air tools to install wheel studs. The serrations can be stripped from the stud.
1. Insert a new wheel stud in the hole in the axle flange or hub flange, making sure serrations are aligned with those made by the original wheel stud.
2. Seat new wheel stud in axle flange or hub flange.
-
Place four flatwashers over the outside end of the wheel stud.
-
Thread a standard lug nut with the flat side against the washers.
-
Tighten the lug nut until the wheel stud head seats against the back side of the flange.