Econoline E350 1 Ton V8-7.3L DSL Turbo VIN F (1998)
Engine Control Module: Reset Procedure
The Powertrain Control Module (PCM) Reset allows the scan tool to command the PCM to clear all emission-related diagnostic information. When
resetting the PCM, a DTC P1000 will be stored in the PCM until all the OBD II system monitors or components have been tested to satisfy a drive cycle,
without any other faults occurring. Clearing codes from the vehicle-specific RETRIEVE/CLEAR CONTINUOUS DTCs will clear all systems, except
the IDM (see KOEO On-Demand Self Test), including OBD II systems. Clearing codes from the OBD II generic menu will only clear OBD II features
for the 7.3L diesel.
The following events occur when a PCM reset is performed:
-
Clears the number of Diagnostic Trouble Codes (DTC).
-
Clears the DTCs.
-
Clears the freeze frame data.
-
Resets status of the OBD II system monitors.
-
Sets DTC P1000 as a vehicle-specific DTC. P1000 will not appear as an OBD II code.
New Generation Star
-
Turn key OFF.
-
Perform the necessary vehicle preparation and visual inspection.
-
Select VEHICLE & ENGINE SELECTION menu (optional).
-
Select NEW VEHICLE YEAR & MODEL.
-
Select year, engine, model with the appropriate qualifier, if needed (for example, transmission, 49 States, California).
-
Follow operating instructions from the menu.
-
Select GENERIC OBD II FUNCTIONS.
-
Press CONT button if all OBD II monitors are not complete.
-
Turn key ON.
-
Select CLEAR DIAGNOSTIC CODES.
-
Press START Key.
Generic Scan Tool
Refer to the scan tool manufacturer's manual for specific instructions.
Resetting Keep Alive Memory (KAM)
Disconnect the negative lead from the battery for a minimum of 5 minutes. After KAM has been reset, DTCs P1000 and P0603 will be stored in the
PCM.