Econoline E350 1 Ton V8-7.3L DSL Turbo VIN F (1998)
16. Using the Seal Remover and Impact Slide Hammer, remove and discard the pinion seal.
17. Remove the oil slinger and pinion bearing.
18. Remove the outer pinion bearing cup.
-
For Dana 60/70 axles, use the Driver Handle and the Pinion Bearing Cup Remover.
-
For Dana 80 axles, use the Outer Pinion Bearing Cup Remover.
CAUTION: Do not nick the bore of the rear axle differential carrier.
19. Using the Driver Handle and the Pinion Bearing Cup Remover, remove the inner pinion bearing cup and the drive pinion shims.
NOTE: If the drive pinion shims are bent or nicked, replace as necessary. If the drive pinion shims are to be replaced, measure the shim(s) and
replace with the same thickness.