Econoline E550 V10-6.8L VIN S (2003)
INSTALLATION
1. Install the output shaft speed (OSS) sensor.
1. Lubricate and install the output shaft speed (OSS) sensor.
2. Install the bolt.
2. Install the turbine shaft sensor (TSS).
1. Lubricate and install the turbine shaft sensor (TSS).
2. Install the bolt.
Caution: Be sure not to raise the back of the transmission too high, if it makes contact with the underbody, damage to the sensors will occur.
3. Install the rear transmission mount.
1. Raise the transmission mount.
2. Install the rear transmission mount.
3. Install the bolts.
4. Lower the transmission on to the rear crossmember support.
5. Install the rear transmission mount nuts.