Econoline E550 V10-6.8L VIN S (2003)
7. NOTE: This step duplicates final pinion bearing preload.
Tighten the special tool to the specification shown.
8. NOTE: The special tool must be offset to obtain an accurate reading.
Rotate the special tool several half-turns to make sure of correct seating of the pinion bearings and position the special tool.
9. Install the special tool.
1
Position the special tool.
2
Install the differential side bearing caps.
3
Install the four differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims must be flat and clean. A slight drag should be felt for correct shim selection. Do not attempt to
force the pinion shim between the Gauge Block and the Gauge Tube. This will minimize selection of a pinion shim thicker than required, which
results in a deep tooth contact in final assembly of integral rear axle assemblies.