Econoline E550 V10-6.8L VIN S (2003)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Rear, Three-Piece
Driveshaft - Rear, Three-Piece
Removal
1. Raise and support the vehicle.
2. Index-mark the driveshaft at the axle flange.
3. Disconnect the driveshaft from the axle flange.
1. Remove and discard the bolts.
2. Remove and discard the U-joint retainers.
-
Using mechanics wire, support the driveshaft.
4. Disconnect the driveshaft from the coupling shaft.
1. Remove and discard the bolts.
2. Remove and discard the U-joint retainers.
-
Using mechanics wire, support the driveshaft.