Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
13. NOTE: During assembly, the differential pinion thrust washer and the differential pinion gear holes must align exactly with those in the
differential case.
Assemble the differential pinion thrust washers into the differential case.
-
Use a very small screwdriver to push the washers into place.
14. Remove all the tools from the differential case.
15. Install the differential pinion shaft.
16. Install the differential pinion shaft lock pin.
17. If removed, install the differential ring gear.
-
Tighten the Grade 9 bolts to 176 Nm (130 ft. lbs.).
Differential Case and Ring Gear - Model 70, Limited Slip
Differential Case and Ring Gear - Model 70, Limited Slip