Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
![background image](/ford/econoline_e550/v8-7.3l_dsl_turbo_vin_f/Page-1571003.png)
1. Press the dust slinger on the coupling shaft.
2. NOTE: Install the bearing on the coupling shaft with the turned-in lip toward the dust slinger.
NOTE: Install the driveshaft center bearing bracket with the deep flange facing rearward.
Install the driveshaft center bearing support on the coupling shaft.
1
Install the rubber insulator in the driveshaft center bearing bracket.
2
Using a suitable press, install the driveshaft center bearing support assembly on the coupling shaft.
3. Install the driveshaft center bearing retainer.
4. Position the driveshaft slip-yoke boot clamp on the coupling shaft stub shaft.
5. Slide the small opening end of the slip-yoke boot on the coupling shaft stub shaft, as far as it will travel.