Edge AWD V6-3.5L (2009)
Radio/Stereo: Service and Repair
Satellite Digital Audio Receiver System (SDARS) Module
Removal and Installation
NOTE: This procedure applies to vehicles without navigation, which has the satellite radio receiver built-in to the Audio Control Module (ACM).
1. NOTE: Module configuration is required when a new Satellite Digital Audio Receiver System (SDARS) module is being installed.
Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation
(PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming
and Relearning
2. Remove the liftgate scuff plate.
3. Remove the 2 nuts and the SDARS module.
-
Disconnect the satellite radio antenna connector and the electrical connector.
-
To install, tighten the nuts to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure.
-
Download the configuration information to the SDARS module. For additional information, refer to PMI in Information Bus. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning