Edge AWD V6-3.5L (2009)
The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
-------------------------------------------------
Pinpoint Test B: DTC B1317
Driver Seat Module (DSM)
Pinpoint Tests
Pinpoint Test B: DTC B1317
Refer to Wiring Diagram Set 117, Remote Keyless Entry and Alarm for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Normal Operation
-
DTC B1317 (Battery Voltage High) - a continuous memory DTC that sets when the Driver Seat Module (DSM) detects battery voltage above 15
volts on circuit SBB45 (GY/RD).
This pinpoint test is intended to diagnose the following:
-
Charging system concern
-
DSM
PINPOINT TEST B: DTC B1317
NOTE: DTC B1317 may be stored in the module memory due to previous battery charging or vehicle jump starting events.
-------------------------------------------------
B1 CHECK FOR DTC B1317, B1676 OR P0563 SET IN OTHER MODULES
-
Ignition ON.
-
Enter the following diagnostic mode on the scan tool: (All Modules) Self-Test.
-
Retrieve the continuous memory DTCs from all modules.
-
Is DTC B1317, B1676 or P0563 (PCM) set in more than one module?
Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to B2.
-------------------------------------------------
B2 CHECK THE BATTERY VOLTAGE
-
Turn off all interior/exterior lights and accessories.
-
Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage.
-
Does the battery voltage rise to 15 volts or higher?
Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to B3.
-------------------------------------------------
B3 RECHECK FOR DTC B1317
-
Turn the engine off.
-
Ignition ON.
-
Enter the following diagnostic mode on the scan tool: DSM Self-Test.
