Edge AWD V6-3.5L (2009)
At the point that each of the first 2 thresholds are exceeded, DTC B106E sets along with the DTC relating to the affected circuit. Once the final (third)
threshold is exceeded, the affected output is permanently disabled, and DTC B106F sets along with DTC B1342, at which time the SJB must be
replaced.
-
DTC B106E (Solid State Driver Disabled Due to Short Circuit) - sets when the SJB has disabled a circuit due to a repetitive fault causing a circuit
overload. A corresponding DTC for the circuit in question will also set.
-
DTC B106F (Module Disabled Due to External Fault) - sets when one or more output functions are permanently disabled due to a repetitive circuit
overload fault. DTC B106F sets with DTC B106E. When DTC B106F is present, a new SJB must be installed after the fault condition has been
corrected.
This pinpoint test is intended to diagnose the following:
-
Output circuit short to ground or voltage
-
SJB
PINPOINT TEST F: DTC B106E
NOTICE: If DTC B106F is present and a new Smart Junction Box (SJB) is to be installed, the fault condition must be corrected first. Failure to
correct the fault condition first may cause damage to the new SJB, resulting in a repeat repair.
NOTE: If DTC B106F is present, DTC B1342 may also be present. At this time, ignore these DTCs and follow the necessary diagnostics to resolve
DTC B106E and any other DTCs that are present. DTC B106E will be present only when there is another DTC due to a software issue or a circuitry
issue that must be resolved before another self-test is run. Each time a self-test is run, one of the 3 thresholds is used. Once the 3 thresholds are used,
DTCs B106F and B1342 will be present and the SJB must be replaced. All other DTCs MUST be resolved first, or else the new SJB will begin to have
its 3 thresholds used with each self-test that is run.
-------------------------------------------------
F1 REVIEW THE DTCs
-
Review the DTCs from the SJB self-test.
-
Are only DTCs B106E and B106F present?
Yes
INSTALL a new SJB. REFER to Smart Junction Box (SJB) See: Power and Ground Distribution/Power Distribution Module/Service and Repair. TEST
the system for normal operation.
No
CORRECT any DTCs present other than DTCs B106E and B106F. REFER to Diagnostic Trouble Code (DTC) Chart See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) Chart. After the repair, GO to F2.
-------------------------------------------------
F2 CARRY OUT THE SJB SELF-TEST
-
Carry out the SJB self-test.
-
Is only DTC B106F present (DTC B1342 may also be present)?
Yes
INSTALL a new SJB. REFER to Smart Junction Box (SJB) See: Power and Ground Distribution/Power Distribution Module/Service and Repair. TEST
the system for normal operation.
No
The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
-------------------------------------------------
Pinpoint Test G: DTC B1317
Smart Junction Box (SJB)
Pinpoint Tests