Edge AWD V6-3.5L (2009)
Front Door Window Motor: Service and Repair
Window Regulator and Motor - Front Door
Window Regulator and Motor - Front Door
Removal and Installation
NOTE: LH shown, RH similar.
NOTE: The front window motor must be de-initialized, then initialized whenever the LH or RH (MKX) or LH (Edge) front window motor is removed
from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any
operation in which grease or lubricants are applied to the window regulator or glass run.
Window operating/not operating
1. Remove the front door speaker.
Window not operating
NOTE: Cutting the regulator cable should only be done if installing a new window regulator assembly.
2. NOTE: Support window glass before cutting the window regulator cable.
Cut the window regulator cable.
Window operating
3. Reconnect the window control switch.
Window operating/not operating
4. Remove the access plugs and lower the window until the glass clamp bolts can be accessed through the 2 access holes. Tape the glass in position.
5. NOTE: If the window regulator cable was cut previously, support the regulator before the glass clamp bolts are loosened.
Loosen the glass clamp bolts.
-
To install, tighten to 8 Nm (71 lb-in).
6. Lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
7. If equipped, remove trim and disconnect the power mirror electrical connector.
-
Remove the wiring harness pushpins from the door.