Edge AWD V6-3.5L (2009)
Trunk / Liftgate Motor: Service and Repair
Power Liftgate Motor
Removal and Installation
1. Remove the power liftgate rod assembly. For additional information, refer to Power Liftgate Rod See: Trunk / Liftgate Shock / Support/Service
and Repair.
2. Disconnect the power liftgate motor electrical connectors.
3. Remove the power liftgate motor retaining bolts and remove the power liftgate motor assembly.
-
To install, tighten to 11 Nm (97 lb-in).
4. Position the back end of the rear quarter trim out enough to access the top power liftgate motor retaining bolt.
5. To install, reverse the removal procedure.
-
Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization See: Service and Repair/Procedures.