Edge AWD V6-3.5L (2009)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry (RKE) Transmitter Programming
Remote Keyless Entry (RKE) Transmitter Programming
NOTE: This procedure is for programming conventional keyfobs only. The Remote Keyless Entry (RKE) transmitter of the Integrated Keyhead
Transmitter (IKT) is programmed automatically during the Passive Anti-Theft System (PATS) programming. For additional information, refer to Key
Programming Using Two Programmed Keys or Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment in Antitheft and
Alarm Systems to program the IKT. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and
Relearning/Key Programming Using Two Programmed Keys See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and
Inspection/Programming and Relearning/Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment
NOTE: All RKE transmitters must be programmed at the same time.
NOTE: Do not apply the brake pedal during this sequencing, as doing so ends the sequence and the transmitters will not be programmed.
1. Electronically unlock the door locks using the door lock control switch.
2. Cycle the ignition switch from the OFF to the RUN position 8 times in rapid succession (within 10 seconds), with the eighth turn ending in RUN.
If the module successfully enters program mode, it locks and then unlocks all the doors.
3. NOTE: If no action is taken within 20 seconds after a transmitter has been programmed, the programming sequence ends (the doors lock and
unlock to confirm that programming is complete).
Within 20 seconds, press any button on the RKE transmitter to be programmed. The doors lock and then unlock to confirm that each RKE
transmitter is programmed. Repeat this step for each RKE transmitter.
4. Exiting the programming mode is accomplished if one of the following occurs:
-
The key transitions to the OFF position.
-
20 seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number (4) of RKE transmitters have been programmed.
5. Check the operation of the RKE transmitter. If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and
press the button again. If the door locks still fail to respond, refer to Locks, Latches and Entry Systems. (Make sure that no more than the
maximum number of RKE transmitters are attempted to be programmed.)
Autolock and Auto-Unlock Programming
Autolock and Auto-Unlock Programming
Programming the Autolock Feature Using the Door Lock Control Switch
NOTE: The autolock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE: The autolock feature of the Smart Junction Box (SJB) can also be configured ON or OFF with the scan tool. For additional information on
module configuration, refer to Information Bus.
NOTE: When programming the autolock feature using the door lock control switch method, the following steps must be carried out within 30 seconds or
the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
1. NOTE: Prior to beginning, make sure the ignition key is in the OFF position and all vehicle doors are closed.
Turn the ignition key from the OFF to the ON position.
2. Press the unlock button on the door lock control switch 3 times.
3. Turn the ignition key from the ON to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition key to the ON position. The horn chirps once to indicate that programming mode is entered.
