Edge AWD V6-3.5L (2009)
the same position.
Remove the LH and RH rear 12 front guide track-to-housing screws.
9. NOTE: Carefully mark the location of each shade track in 3 places before removing any fasteners. The shade tracks must be installed in exactly
the same position.
NOTE: LH shown, RH similar.
Remove the LH and RH 6 rear shade track-to-housing screws.
10. NOTICE: Support the sliding glass motor block and drive tube assembly.
NOTE: Protect the vehicle interior from cable grease.
With the rear of the front guide tracks lowered, carefully pull the front shade guide feet out of the rear of the front guide tracks to release the cable.
Remove the shade tracks and the motor block and tube assembly as one unit.
11. NOTE: LH shown, RH similar.
Remove the LH and RH rear shade track-to-drive tube bracket screws and pull the motor block tube out of the shade track.
12. NOTE: LH shown, RH similar.
Remove the LH and RH rear shade track stop screws.
13. NOTE: If installing a new LH or RH rear shade track, use the cable supplied with the replacement unit.
Pull the shade cables through the front of the shade track assemblies.
Installation
