Edge AWD V6-3.5L (2009)
7. NOTE: LH shown, RH similar.
Install the remaining 4 rear shade track-to-housing screws.
-
Align the track to the marks previously made. Tighten to 5 Nm (44 lb-in).
8. NOTE: LH shown, RH similar.
Install the LH and RH rear drive tube bracket-to-housing screws.
-
Tighten to 5 Nm (44 lb-in).
9. NOTE: Be careful not to overtighten cable wraps during assembly to prevent crimping the cable sheath.
NOTE: The cable wraps must be reinstalled at the exact same locations.
Install new cable wraps to the shade motor block and drive tube assembly.
10. NOTE: Do not install the headliner at this time.
Install the front and rear shade assemblies but do not carry out the roof opening panel motor initialization at this time. For additional information,
refer to Roof Opening Panel Motor - Shade See: Roof Opening Panel Motor - Shade.
