Edge AWD V6-3.5L (2009)
Sunroof / Moonroof Panel: Service and Repair
Roof Opening Panel Glass - Front Sliding
Roof Opening Panel Glass - Front Sliding
Removal and Installation
1. Open the roof opening panel to the VENT position.
2. Detach the top of the concertina blind from the moving glass frame.
3. Reposition the sliding glass panel to any position rearward of VENT position.
4. Remove the 4 roof opening panel glass front screws.
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the 2 roof opening panel glass rear screws.
-
To install, tighten to 8 Nm (71 lb-in).
6. NOTICE: It is possible for the idler mechanism to move freely once the glass panel is removed. Do not move the idler rearward or it may
disengage from the idler track.
Carefully remove the roof opening panel glass.
7. To install, reverse the removal procedure.
-
Initialize the roof opening panel motor(s). For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.