Edge AWD V6-3.5L (2009)
12. Release the retainers and remove the back panel.
13. Remove 2 screws and the outboard upper side shield.
14. Remove 2 screws and the inboard upper side shield.
15. Remove 2 screws and the outboard lower side shield.
16. Remove 2 screws and the inboard lower side shield.
17. WARNING: Keep hands clear of all moving seat mechanisms when releasing the recliner lever. The recliners are spring loaded and
release with high force. Failure to follow these instructions may result in serious personal injury.
NOTE: Note the position of the safety belt buckle anti-rotation tab for installation.
With the recliners released (backrest folded), remove the bolt and safety belt buckle.
-
To install, tighten to 65 Nm (48 lb-ft).
18. Separate the recliner cable casing at both ends from the recliners.
19. Remove the recliner cable in the following sequence.
1. Turn the cable end so the tab aligns with the slot in the lever and separate the cable at one end.
2. Turn the cable end so the tab aligns with the slot in the lever and separate the cable at the other end.
-
Remove the recliner cable.
20. If equipped, remove the power fold motor in the following sequence.
1. Remove the 2 screws from the power fold motor.
2. Slide the cable casing out of the recliner.
3. Turn the cable end so the tab aligns with the slot in the lever and separate the cable.
4. Remove the power fold motor.
21. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To assemble, reverse the disassembly procedure.
-
Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in the
diagnosis and testing portion of Seat Belt Systems. See: Restraint Systems/Seat Belt Systems/Testing and Inspection/Component Tests and
General Diagnostics
-
Make sure the lower anchors and tethers for children are accessible to the occupant.