ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Removal and Replacement|Page 8025 > < Removal and Replacement|Page 8023
Page 6
background image

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

NOTE: Driver seat shown, passenger similar.

All seats

1. Remove the front seat cushion. For additional information, refer to Seat Cushion - Front  See: Removal and Replacement/Front Seats.

2. Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.

3. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from

the cushion foam pad.

NOTE: A new heater mat will come assembled on a new foam pad.

Remove the cushion trim cover from the cushion foam pad in the following sequence.

1. Separate the hook-and-loop strips.

2. Separate the cushion trim cover wire retainer from the clips in the cushion foam pad.

-

For vehicles with climate controlled seat, on assembly make sure the climate control seat manifold is in place before snapping the cushion
trim cover wire retainer back into the cushion foam pad.

Seats with climate control

4. Remove the cushion climate control seat manifold from the cushion foam pad.

5. Remove the 3 cushion Thermo-Electric Device (TED)-to-cushion frame screws.

6. Remove the cushion TED-to-climate control seat cushion adapter screw and remove the TED.

7. Release the clips and remove the cushion TED adapter from the cushion frame.

All seats

8. If equipped, remove the screw and the heated seat module.

9. Release the retainers from the cushion frame and remove the cushion support.

10. To assemble, reverse the disassembly procedure.

-

For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing - Front Passenger Cushion  See: Service and
Repair/Front Seats/Seat Wire Harness Routing - Front Passenger Cushion.

Seat Cushion - Rear, 40 Percent

Seat Cushion - Rear, 40 Percent

NOTE: A new heater mat will come assembled on a new foam pad.

Removal and Replacement|Page 8025 > < Removal and Replacement|Page 8023