Edge AWD V6-3.5L (2009)
4. Remove the head restraint.
1. Using an appropriate tool, push in the hole, lift up on the head restraint and release one side of the head restraint.
2. Push the release button and remove the head restraint.
5. Pull out and remove the 2 head restraint guides.
-
Discard the slave head restraint guide.
-
For installation, install a new slave head restraint guide.
6. NOTICE: When installing, make sure the side air bag module wiring harness is not pinched between the side air bag module and
backrest frame or damage to the wiring harness can occur.
Through the rear of the seat, remove and discard the 2 side air bag module bolts and separate the side air bag module from the seat backrest.
-
For installation, install 2 new side air bag module bolts.
-
Tighten to 23 Nm (17 lb-ft).
7. NOTICE: Do not pull the side air bag module electrical connector out by the locking button. Damage to the locking button can occur.
NOTICE: Do not install the side air bag module electrical connector by the locking button. Damage to the locking button can occur.
NOTICE: The side air bag module electrical connector locking button must be in the released position when the connector is being
installed or connector damage may occur.
NOTICE: The side air bag module electrical connector is unique and cannot be reversed when connected to the side air bag module.
Match the electrical connector key to the keyway in the side air bag module. Do not force the electrical connector into the side air bag
module or damage can occur.
Using a small screwdriver as shown, lift up and release the locking button on the side air bag module electrical connector. With the locking button
released, remove the electrical connector and the side air bag module.