Edge AWD V6-3.5L (2009)
Seat Heater Control Module: Service and Repair
Dual Climate Controlled Seat Module (DCSM)
Dual Climate Controlled Seat Module (DCSM)
Removal and Installation
NOTE: When installing a new Dual Climate Controlled Seat Module (DCSM), it is necessary to carry out Programmable Module Installation (PMI).
See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Before removing the DCSM, carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
2. Remove the front passenger seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
3. Remove the DCSM.
-
Disconnect the 3 electrical connectors.
-
Remove the 2 screws.
-
Remove the DCSM.
4. To install, reverse the removal procedure.
5. Install the front passenger seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
6. Install the DCSM software data. Carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning