Edge AWD V6-3.5L (2009)
![background image](/ford/edge_awd/v6-3.5l/Page-1478001.png)
Acceleration/Deceleration Sensor: Service and Repair
Stability Control Sensor Cluster
Removal and Installation
NOTE: When installing a new stability control sensor cluster, the sensor cluster must be calibrated. Follow the scan tool directions for the calibration
procedures.
1. NOTE: The sensor is located on the RH side of the vehicle, under the rear seat.
Remove the rear seat.
2. Remove the right rear scuff plate.
-
Position the carpet aside.
3. Disconnect the stability control sensor cluster electrical connector.
4. Remove the 2 stability control sensor cluster nuts and the stability control sensor cluster.
-
To install, tighten to 9 Nm (80 lb-in).
5. To install, reverse the removal procedure.
-
Carry out the IVD Initialization sequence. Follow the scan tool directions.