Edge AWD V6-3.5L (2009)
Fan Shroud: Service and Repair
Cooling Fan Motor and Shroud
Removal and Installation
1. Remove the Air Cleaner (ACL) assembly.
2. If equipped, detach the 2 block heater wiring clips from the radiator support.
3. Detach the wiring harness retainers and position the harness aside.
4. Position aside the upper radiator hose from the cooling fan motor and shroud.
5. Disconnect the cooling fan motor electrical connector.
6. If equipped, remove the bolt and position aside the oil cooler bracket.
-
To install, tighten to 6 Nm (53 lb-in).