Edge AWD V6-3.5L (2009)
28. Detach the wiring harness retainer from the RH valve cover stud bolt.
29. Remove the bolt and the ground wire from the engine front cover.
30. Remove the nut, the ground wire and the radio interference capacitor wire from the engine front cover stud.
31. Loosen the exhaust flexible pipe clamp and disconnect the 2 exhaust hangers.
32. Remove the 4 nuts and the exhaust flexible pipe and Y-pipe as an assembly.
-
Discard the nuts and the gasket.
33. Remove the 3 pin-type retainers, the 7 screws and the radiator splash shield.