Edge AWD V6-3.5L (2009)
3. Using a new gasket, install the RH valve cover and tighten the bolt and 10 stud bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
4. Attach all of the wiring harness retainers to the valve cover and the stud bolts.
5. Connect the 3 RH fuel injector electrical connectors.
6. Connect the RH VCT solenoid electrical connector.
7. Connect the RH HO2S electrical connector.
8. Connect the RH CMS electrical connector and pin-type retainer.
9. Connect the PSP switch electrical connector.
10. Install the RH ignition coils.