Edge AWD V6-3.5L (2009)
3. Remove the 4 nuts, the exhaust flexible pipe and the Y-pipe as an assembly.
-
Discard the nuts and the gasket.
4. Remove the 2 nuts and the roll restrictor heat shield.
5. Loosen the roll restrictor-to-subframe through bolt.
6. Remove the roll restrictor through bolt and the 2 roll restrictor-to-transaxle bracket plate bolts.
7. Remove the 3 bolts and the transaxle bracket.
8. NOTICE: The Oil Pan Holding Fixture must be carefully aligned to the mounting bosses on the oil pan. Failure to follow these
instructions may result in damage to the oil pan.
Position a floor jack and the Oil Pan Holding Fixture under the oil pan.