Edge AWD V6-3.5L (2009)
Removal
1. Remove the Air Cleaner (ACL) outlet pipe.
2. Disconnect the Throttle Body (TB) electrical connector.
3. Disconnect the Evaporative Emission (EVAP) tube from the intake manifold.
4. Disconnect the brake booster vacuum hose from the intake manifold.
5. Disconnect the PCV tube from the PCV valve.
6. Detach the wiring harness retainers from the upper intake manifold.
7. Remove the upper intake manifold support bracket bolt.
8. Remove the 6 bolts and remove the upper intake manifold.
-
Remove and discard the gaskets.
-
Clean and inspect all of the sealing surfaces of the upper and lower intake manifold.
Installation
1. NOTICE: If the engine is repaired or replaced because of upper engine failure, typically including valve or piston damage, check the
intake manifold for metal debris. If metal debris is found, install a new intake manifold. Failure to follow these instructions can result in
engine damage.
Using new gaskets, install the upper intake manifold and the 6 bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
2. Install the upper intake manifold support bracket bolt.
-
Tighten to 10 Nm (89 lb-in).
3. Attach the wiring harness retainers to the upper intake manifold.
4. Connect the PCV tube to the PCV valve.
5. Connect the brake booster vacuum hose to the intake manifold.
