Edge AWD V6-3.5L (2009)
Using the Crankshaft Vibration Damper Replacer and Front Crankshaft Seal Installer, install a new crankshaft front seal.
41. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using the Crankshaft Vibration Damper Replacer and Front Cover Oil Seal Installer, install the crankshaft pulley.
42. Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
-
Stage 1: Tighten to 120 Nm (89 lb-ft).
-
Stage 2: Loosen one full turn.
-
Stage 3: Tighten to 50 Nm (37 lb-ft).
-
Stage 4: Tighten an additional 90 degrees.
43. Install the accessory drive belt, tensioner and the power steering belt.
44. NOTICE: Do not expose the Motorcraft(R) High Performance Engine RTV Silicone to engine oil for at least 90 minutes after installing
the engine front cover. Failure to follow this instruction may cause oil leakage.
Fill the engine with clean engine oil.
45. Connect the battery ground cable.
46. Evacuate and recharge the A/C system.