Edge AWD V6-3.5L (2009)
Removal
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while
cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the A/C system.
3. Disconnect the battery ground cable.
4. Remove the accessory drive belt, tensioner and the power steering belt.
5. Using the Strap Wrench, remove the crankshaft bolt and washer.
-
Discard the bolt.
6. Using the 3 Jaw Puller, remove the crankshaft pulley.
7. Using the Oil Seal Remover, remove and discard the crankshaft front seal.
8. Loosen the exhaust flexible pipe clamp and disconnect the 2 exhaust hangers.