Edge AWD V6-3.5L (2009)
Muffler: Service and Repair
Muffler and Tailpipe
Muffler and Tailpipe
Removal and Installation
NOTE: Do not use oil or grease-based lubricants on the isolators. They may cause deterioration of the rubber.
NOTE: Oil or grease-based lubricants on the isolators may cause the exhaust hanger isolator to separate from the exhaust hanger bracket during vehicle
operation.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Support the muffler and tailpipe with a suitable jackstand.
3. Remove the Torca(R) clamp. For additional information, refer to Torca(R) Clamp See: Service and Repair/Torca(R) Clamp.
4. NOTE: Do not damage or tear the isolators during removal.
Using soapy water, separate the 4 muffler and tailpipe isolators from the vehicle.
5. Separate the muffler and tailpipe from the exhaust flexible pipe and remove the muffler and tailpipe.
6. To install, reverse the removal procedure.
-
Inspect and replace any isolators damaged or torn during the removal process.
7. Start the engine and check for exhaust leaks.